930 Series Mortice Exit Device
Tested to the requirements of BS EN 1125:1997+A1: 2001

Life safety device designed to fit timber or hollow steel door applications. Mounting is achieved by through-the-door binder posts. Available in two backset sizes, 38.1mm and 69.9mm to clear the deep stops of timber and hollow steel door jambs. Bar mounting screw access is from inside the bar only. The device has an all-steel latch case with an oil impregnated solid brass bolt and deadlatching mechanism. Unique tab system allows the flat faceplate to be used to suit bevelled door sections.
Options include: Monitoring or Cylinder Dogging. If required, the 930 Series will accept any standard mortice cylinder (with MS® cam) allowing key access from the external side of the door. A full range of Adams Rite Entry Trim is also available.
NOTE: As standard the 930 is designed to fit a 44/45mm thick door section. Bars are available with an extended drive to suit thicker doors, however these are non-stock items and would be classed as a special order item. In timber applications, the 930 can be fixed with wood screws as an alternative to binder posts.

	Standards: Tested to the requirements of BS EN 1125:1997+A1: 2001
	Projection: 76.5mm from face of door.
	Push Bar Face Width: 62mm.
	Back Bar Width: 70mm.
	Door Opening Widths: Five standard sizes - 600mm, 750mm, 900mm, 1050mm, 1200mm.
	Width Variations: For dimensional limitations click here.
	Push Bar: Extruded Aluminium Alloy. Removable for Polyester Powder Coating if required.
	Dogging Facility: Built-in. Operated by dogging key (two supplied). NOTE: Not available on 600mm door opening width bar.
	Case: Steel with corrosion-resistant plating.
	Latch Backsets: 38.1mm and 69.9mm.
	Latch Bolt: 25.4mm x 16mm. Oil impregnated solid brass. Hardened steel internal pins, plus anti-pick baffle.
	Bolt Throw: 15.3mm.
	Auxiliary Bolt: Stainless Steel Pin.
	Door Gap: Maximum 5mm.
	Forend: Steel, with aluminium faceplate.
	Handing: Field adjustable.
	‘Push Bar to Open’ sticker included